Just found that ENJO makes weld in motor mounts for the swap... The swap comes with all of this, out of a 92-95 Prelude:

- Motor
- Hydraulic Tranny
- ECU (P13)
- Axles with Half Shaft
- Shifter Cables
- Shifter Assembly
- Stock Motor Mounts *
- Alternator
- Starter
- Clutch
- Flywheel
- Intake Manifold
- Exhaust Manifold
- Fuel Rail
- Injectors
- Distributor
- Engine Harness
- Comes With All Sensors Needed
- LSD Tranny (Optional +$300)

OK, Im pretty sur the shift linkage WONT work. But my biggest concern is the axles with half shaft will these work??

-I think Ive found alot of good info on this swap so far, it shouldnt be too hard... We got weld in mounts, aftermarket axels from RAxels.com(IF NEEDED), as well as the throttle linkage....

Also, what is gonna need to be done about the tach???

Thanks alot for all the hrlp