Re: ARG!!! My car is a piece! sick of it..is yours?
Ok... Bought the car and ran fine but needed paint job bad. Then I was brillant and wanted a motor swap also.
Paint place fucked me over, body kit molded on sides isnt smoothed right.
Paint laquer wasnt sanded down after it was done..and still isnt.
Had to buy all new weather seals since they were fucked - del sol...not cheap almost a 1,000.00
- Parts missing since paint job was done still need to be bought - 150.00 worth.
- The wipers arms werent but back into gear right, they still sorta work but have no intermentent wipers and when I turn them off they dont go down they stop wherever they are at so I have to time it right.
-- Interior parts and locks not put back in right so everything doesnt work smoothly like it should.
-- The 18s on it right now have tires to big on them to allow me to lower it back down.
--- The exhaust doesnt line up perfectly with the bodykit on the rear so some of the smoke goes all through the bumber and out the sides
-- Only one seat ((dont ask long story)) so I bought S2K seats not knowing I need all the del sol seat parts to make it work right. Now one S2K seat is in and looking for del sol seat parts. The Idle air control valve is stuck open so car revs at 1700 RPM all the time and is really annoying a new one of these is 250 bucks so I need to pull it off and clean it to see if that fixes it.
-- The original steering wheels airbag system wasnt working, SRS light always on.So now I have an aftermarket one but I need to wire up the damn horn so I can pass state inspection.
-- The fog lights were fiberglassed into the kit by the same dumb asses who painted it and they look nice but point damn near straight up.
-- The interior is crap and Im having to replace everything or look at getting it reupholstered.
-- The right turn signal/ driving light bulb plug only has 2 wires going into it instead of three and the 3rd plug is so messed up I need to get a new one so that it will work as both the driving/ signal light
-- Side turn signals dont work but cant go back to stock since the body place filled in the holes so much only the wires will go through and I cant find any stick on ones around here.
This car continues to swallow up money like a drunk uncle swallows egg nogg at the family Christmas party!
Im fed up with it and just about ready to get rid of it and go back to a new car.
Although the B18C6 in it pulls rather nicely and it is nice to have a drop top car....