what car is it going into? are you doing the jdm 5 lug converstion? or is already converted to 5 lug??

if your getting a 96-97 spec type-r motor, the axles will work
if your getting a 98 n up motor, the axles will be an issue.look below on these

GSR/SI 4 lug = 32mm (inner and outer)
CTR/USDM 5 lug/96-97 JDM spec = 32mm (inner and outer)
98 n up JDM ITR = 36mm outer 32mm inner

if you are 4 lugged, only the half shaft(intermediate) off the jdm itr axles will work, you will need to use 93-97 vtec delsol/99-00 si or any integra outers. I have heard if you use 4x 114 prelude hub and spline and it will work, but im not sure

if you are usdm 5 lugged, basically the same thing as above, unless you use the hub off a 97 + Prelude which also uses 36mm axles

if you have the jdm 5 lug convertion i wouldnt do it, its just too much pita to always try to locate new axles, or to have custome ones made