Thread: Pipe Bending
View Single Post
Old Mar 8, 2007 | 06:21 PM
  #4  
GaRn's Avatar
GaRn
Registered member
 
Joined: May 2003
Posts: 6,141
Likes: 0
GaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud ofGaRn has much to be proud of
Default Re: Pipe Bending
Originally Posted by FWDDSMKID
Thanks man, is mandrel bending the only way to get uncrimped piping?
yup, but its really not expensive..

I used a multi bend section of 2.5" stainless pipe from performance curve to build my downpipe, it was only 39 bucks.. it had a 180 deg bend and a 45 degree and some straight sections.. I just cut it where I needed the bends to be and pieced it together!
Reply