sorry about that.. little frustrated.. ok heres the run down ...

car was idling while i was waiting for someone, and just came to a stop. No noises , not ruff idle , no nothing.. just dead.. so I though i had run out of gas, as it was low, fixed that , and nothing..
So it was sent to a friends dads shop to take a look at it. we check all the normal signs, between wires, plugs, rotor and cap. nothing. checked for fuel, and it was fine, gas on the plugs, not flooded, but seemed normal. We ran a check on the igintion coil and module, and both seemed to check out w/the resistance tester.

So at this point I am thinking there is a wiring problem running from the distributor through the harness , or possibly at the ecu. which I have no idea where to start check due to the difference in mix. the harness being a B16 & the ecu being from an LS. Now at this point it sits in the parking lot, not running, waiting for me to figure it out. Any help would be great. Thanks!