Thread: CTR pistons, in a LS block??
View Single Post
Old Sep 10, 2007 | 02:37 PM
  #4  
KYLE ROSE's Avatar
KYLE ROSE
Registered Member
 
Joined: Jun 2005
Posts: 438
Likes: 0
KYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud ofKYLE ROSE has much to be proud of
Default Re: CTR pistons, in a LS block??
Piston to head clearance will be fine. You can clay the head and check the clearance but you will be fine. Obviously your compression will be raised. To fit the pistons on the rods you must shave the wrist pin end of the rod down to fit in the piston.
Reply