Technically I'm an idiot for pics, drawings etc on the internet. But everything I have discussed is nothing more than a recreation of what I have found on the internet. Drawings, designs pics can be found everywhere. Do a Google search for Stan Meyer, Browns Gas, Water Car etc..The electrolizer is a simply two anodes submerged in water with a catalyst. 2 volts DC curent is passed between the anodes. The water bubbles, and the resulting gas gererated is Hydrogen and Oxygen. Keeping the electrolizer sealed allows you to bleed off the resulting gas and feed it to the engine. Increasing the surface area of your anodes and using pulsed voltage dramaticly increases the gas output. However this design works well for low demand fuel requirements. My hope is for huge demand load gas production, so I can achieve the required HP I need for the 6 second pass. Please don't think that I am claiming to have developed any of this on my own, everything I have discussed so far has been gleaned from internet research. My hope is to find someone who can give me the key to my final question, splitting water, then I can build the car.