Re: I need help with my pulley!
Originally Posted by
marlinspike
That must've been one hell of a breaker bar. The 1 step up from 1/2" drive is 3/4" drive, which I don't think I have ever seen in an automotive application. Take it back, get a 1/2" drive one. There are 3/4" to 1/2" drive adapters, but no point in doing that when the whole point in doing this is to up the torque.
I just looked at my receipt, says 1/2''Dr17''
got it from Ace hardware. so should i buy a 1/4'' to fit my tools?
Last edited by Djtuner; Mar 19, 2009 at 04:13 AM.