Some updates:

My new Rad came in (Koyo for KA). Fits like it should.



-------------------------------------

since I am lowering the car, I needed to move the wire harness that runs inside the driver side fender.

I removed the fender got rid of the white and black harness holder thingies, hammered as seen in the third pic. I used one hole already there and drilled a hole to attach with zip ties above the ridge. I ran the hood latch cable inside the engine bay through the triangle hole near firewall and along the frame rail.



-----------------------------------------------

I also ran my fuel system using the corvette filter regulator (Wix from Rock Auto). I had to change the configuration of the mounting bracket and used a self tapper to attach under the frame rail.





I used Russell adapter fitting: RUS-640940



I cut down the ends on the filter/regulator and used the factory return line and a new feed that was the perfect size. I removed the hardlines and ran -6AN line up to engine bay. I used heater line with a slit to cover the braided line where it comes in contact with the fuel tank, as not to rupture it.





I will use some heat sleeve where it comes by the header and this fitting to attach to fuel rail: RUS-640853