Thread: 84 s10 355ci for your 2 door honda or acura
View Single Post
Old Oct 19, 2010 | 09:23 AM
  #1  
Pyscolilboy17's Avatar
Pyscolilboy17
Registered Member
 
Joined: Dec 2006
Posts: 533
Likes: 0
From: Natural Bridge
Pyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud ofPyscolilboy17 has much to be proud of
Default 84 s10 355ci for your 2 door honda or acura
Name: Adam
Location: 20 mins north of Roanoke
Means of contact: PM or this thread.
Price: like to have a 2 door teg.

http://s151.photobucket.com/home/pyscolilboy17/index



Vehicle: 1984 Chevy S10 355ci
Miles: unknown on engine. 149,xxx on body
Engine: 350 bored .30 over with pop top pistons. Eldebrock 850cfm carb. Eldebrock performer rpm intake. Don't know much about the top end just that it has roller rockers.
Exterior: roll pan to replace rear bumper.
Interior: bucket seats to replace the bench seat. Steering wheel is not original, I believe it is out of an older caviler. B&M rachet shifter.
Drivetrain: 700r, stock 10 bolt with spyder gears welded.

Bad: the 700r is shot, I have th350 with a shift kit along with an 8.8 Ford with 4.11 gears I will throw in if the car is right. The rear end will have to be narrowed. It could use a respray. The rear roll pan is new so it doesn't match the truck.
Last edited by Pyscolilboy17; Oct 19, 2010 at 08:24 PM.
Reply