Originally Posted by
NasTHatch
You sounded Ignorant when you typed it, so therefore i called you an ignorant bastard, and if you remove pistons from one set of rods you don't just have them mic'd, they need to be checked for balance, and the block needs to be honed for the pistons you are installing and not just honed in general, so say all the info and not just half of it
Yea I was going to elaborate when the OP posted back....I just didnt feel like I should go into the details of engine machining right off the bat if he didnt know how to search well enough to see if those pistons fit..