pilot bearing install

to remove the pilot bushing i use a ton of grease, and a socket with a welded end on it, to force the auto bushing back out.



9/16ths socket for auto bushings

just, smack that fucker in there with a hammer real hard (make sure you pack with lots of grease)
sometimes, i add some eletrical tape to the socket for a better seal



dont forget your MANUAL TRANS BOLTS
they have longer threads and specify MT on them



auto bushing on right, manual on left


tap the new one in


pray you installed your twin disk correctly



and, free junk of the day!






total spent on build

$2.09 on a pilot bushing

im getting trans fluid and coolant dropped off from a friend at toyota, motor should go in tonight