Old Feb 1, 2011 | 03:13 PM
  #5  
The real Ryan's Avatar
The real Ryan
Type-R; Tight Car
 
Joined: Feb 2003
Posts: 3,429
Likes: 0
From: Seattle, WA
The real Ryan has disabled reputation
Default Re: Integra GSR cutting out after Skunk2 intake manifold install.

Originally Posted by L_U_C_K
Tps, or map they might be switched also.
Exactly what I was thinking but he would def have a CEL if this was the case..

Originally Posted by KyleDC2
Yeah the light comes on then turns off when I start it. It just dies completely when I try to pull off.
I can't explain why the CEL isn't on but what you are describing is very much like a TPS/MAP issue fucking your ignition and fuel up. Go unplug your MAP and TPS and switch them and see if it throws a CEL. If it doesn't then try to move the car again. Should only take 5 minutes