Thank you for all the suggestions.

I am runing on adapters. Thinnest avaiable adapter is 15mm = .59 inches which is still too thick, the front is perfect but the back looks retarted with the wheels sticking out because of the offset of the wheel+adapter. Z32's are horrible car when it comes to trying to fit a low offset wheels under those fenders.

I'm getting new wheels anyway, just don't want to get rid of my current wheels so I want to redrill the lug patterns for future use. I've been searching for maching shops but I've never dealt with any before so not sure which one to go to. Any recommendations?