Originally Posted by TeayotaSoupra
I read up on it...it would NOT have been fun...plus I would have had to find a shop to press the bearring out..then do it again to get it back it..would have been a paiiinnn... plus it's the parts that are killer.. ONE bearing was $125..hub is about $300
My dad works at a shop that has all that equipment and more I believe. Where do you think I am welding on my subframes and putting my new clutch and rear end in?
It's hard to do I know but you say you "WANT TO BE A MECHANIC" That is part of it. Joey, my Dad and anyone will tell you they learned most of what they know from tinkering not just reading and things. I know you better then that Nikki. I don't think you're a magazine mechanic or magazine racer....or at least I hope not.
But good luck. What's done is done and what's spent is spent.
