ODR SCCA Autocross at Pungo July 5th
#91
Registered Member
Thread Starter
Join Date: May 2008
Location: Down at the Beach
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Re: ODR SCCA Autocross at Pungo July 5th
I told you that you would be hooked! Only one event and you are already looking for tires and wheels! LOL
295 17's are a popular size, stay away from the oddball stuff if you want to score some take offs.
The vette guys run 315 or 335 18's I think.
How much tire can you fit under you cobra?
295 17's are a popular size, stay away from the oddball stuff if you want to score some take offs.
The vette guys run 315 or 335 18's I think.
How much tire can you fit under you cobra?
#92
Carolina Kracker
Join Date: Oct 2007
Location: BFE
Posts: 2,694
Likes: 0
Received 0 Likes
on
0 Posts
Re: ODR SCCA Autocross at Pungo July 5th
i have 295 35 18s on the back now, i have seen people run the 315s with no spacers. i have a set of 1/2 spacer on the back now just to bring the wheel out even with the fender not for clearance. i need to go and see how much wider the 315 and 335 are over the 295s. on the front, i dont know. i have 265 35 18s on it now. i dont see anything under there that would cause me any issues. i found a set of 17s just like mine on cl for 450 obo, but if i can find people that are running 18s i will get another set of 18" wheels.
#94
Carolina Kracker
Join Date: Oct 2007
Location: BFE
Posts: 2,694
Likes: 0
Received 0 Likes
on
0 Posts
Re: ODR SCCA Autocross at Pungo July 5th
not new, they are expensive, slightly used lol. i have even thought about putting the car back on the alignment rack and marking on the caster camber plates where the diferent *settings are so i can play with it once i am out there. i am suppose to go pick up another set of spindles for it tonight. the 94-95 spindles have a high mounting point for the tie rod ends. if you look under my car, i have the bump steer kit maxed out trying to keep the angles in check. i can roll another 1* of caster into the front (as recommended) but it will throw the tie rod angles off worse. i am going to go to a set of 96-04 spindles, the mount is 1" lower allowing me to get the angles back in line.
its not hard for me to get ate up with it as you can see lol.
the wheels will not come till later, i need to work on fixing the nut behind the wheel before i got making any more changes to the car other than air pressure.
its not hard for me to get ate up with it as you can see lol.
the wheels will not come till later, i need to work on fixing the nut behind the wheel before i got making any more changes to the car other than air pressure.
Thread
Thread Starter
Forum
Replies
Last Post