Fabrik8

So you deleted the intake air temp sensor? If you did, and you have a CEL for it, it's possible that the ECU is going into limp home mode and is running really rich and with conservative timing, which may not start the car very well. Intake air temp is pretty important, especially for a turbo car. That's one of the two main sensors that is needed for a proper air density calculation when using a speed-density engine management strategy instead of a mass airflow sensor based strategy..

12345r

no the iat has nothing to do with the car running at all text me or pm me ill get ur car running

12345r

yes it will have a cel and might run rich but will not cause the car not to start

Fabrik8

It will if the basemap is not in the ballpark to start with. I'm just trying to figure out what we're actually talking about here.

BarePrecision

Were talking about the car is not doing anything at all not trying to start at all not even a lil backfire or anything the basemap is dead
Perfect in the ball park and still nothing and i do not believe the ecu is going into limp mode, it reads the chip and registers it.

Fabrik8

I'm not sure how you're determining that.

12345r

well i give up i told u to text me or u can call me but ur just going back and forth with people in here and it wont get u anywhere but good luck

SYDEWAYZAE86

Hmmm.... evil:

BarePrecision

Changed the inj to stock today n retuned and still nothing tom im doing a compression test.