JDM ITR seats vs, USDM ITR seats
#1
FUCK!
Thread Starter
Join Date: Dec 2003
Location: Virginia Beach
Posts: 857
Likes: 0
Received 0 Likes
on
0 Posts
JDM ITR seats vs, USDM ITR seats
are they the same demensions? I'm planning to swap em' out into my Miata, and I hear the USDM ones fit, I was wondering if the JDM one's shared the same specs.
EDIT: or better yet, if someone had either of these seats, could you measure the base width and shoulder width.
EDIT: or better yet, if someone had either of these seats, could you measure the base width and shoulder width.
Last edited by JamesPrelude; 05-16-2008 at 04:39 PM.
#4
Re: JDM ITR seats vs, USDM ITR seats
I checked these on my JDM recaros, these aren't down to the millimeter or anything but just roughly what they're at. I didn't know if these were the measurements you needed but hopefully it helps, let me know if you needed anything else off of these. I can get you the USDM ones tomorrow if you need.
#5
FUCK!
Thread Starter
Join Date: Dec 2003
Location: Virginia Beach
Posts: 857
Likes: 0
Received 0 Likes
on
0 Posts
Re: JDM ITR seats vs, USDM ITR seats
Actually on the Honda tech boards I heard the JDM one's were shorter, height wize. But that's what they say over there... and yes that's about what I was looking for, howercould I get the across demension from the bottom of the seat, where the bolts would fit in. I'm expecteing the flairyou get with the bolsters. But that's exactly what I was looking for jester.
#7
Re: JDM ITR seats vs, USDM ITR seats
i don't know about the JDM itr seats but i do know that the recaro SRD will fit in the miata. thats what i'm trying to do in my miata. let me know if you find a set cause i'm looking for one also
#8
Yup, jolly poopbuggy
Join Date: Nov 2002
Location: Hampton, VA
Posts: 15,599
Likes: 0
Received 0 Likes
on
0 Posts
#10