Originally Posted by mnnthbx

OK, here's some frsh shots of the final proto-type. Some tweaking will be done to the header to optimize ground clearance on slammed Rucks, but the cone and baffle are final, less one change. The pipe pictured here is black on the inside. We're going back to raw stainless inside, as the black gets scuffed as the baffle is installed. I prefered the raw ID anyway... Oh, it will read "MNNTHBX" in place of "Jardine". :lol:

$240 to mnnthbx@hotmail.com for pre-orders. That price will go up a tiny bit after they're in stock, but for those who wait, I'll hold it and cover the shipping as well. Jardine tells me I'll have 30 units by Halloween. Being out of house, I have less control over the delivery date, though I have no reason to doubt them and expect them to ship as stated.

*It has a look similar to nothing out there. It's a GP megaphone style and it's true to it's design. None of that magaphone shape w/ some wall and tiny hole in the back junk.

*We went ahead and raked it up @ basically the same angle as the fork. It has that nice custom look without having to chop a pipe up.

*It sounds great. I'm amazed we were able to get this much deep growl from such a small pipe. I was worried the entire process it would have some junk open header sound. Farthest thing from the truth...

*It's fast. We have lots of pipes in our crowd, and are very familiar with most the common players. We pulled a Dr D off what became our test bike to put this on, and instantly gained solid speed everywhere.

*There is enough spacing to the tire to allow anyone to mount a fatty wheel and tire with no need to modify the exhaust to fit.

*It has to be the lightest full exhaust on the market.

*As with all our stuff, we skipped the greed, and will offer it @ what should make it one of the cheapest pipes on the market.

Big rake, clean welds...




Plenty of room, fatty ready...






I love the fact the mount is so small and clean, it almost disappears...




NOTE: In full disclosure, it is louder than all the pipes we have here. Not ear bleeding loud, but nowhere near quite, so if that's a downer to you, this is not your exhaust. The camera doesn't do the tone very much justice, though it will do for now...

http://www.vimeo.com/28556181

Originally Posted by 連続注入

Ah you need to let me get that bar Kenny, so I can make a jig for it. Thats what JT is after.

Originally Posted by kenny_el2003

this is not the RE-bar, this is a mini Z drag bar. the other one is not even here yet