3 bar map sensor
#11
Re: 3 bar map sensor
you can get the wire diagram from your motor if you google or look the back of a haynes book for the original sensor, then get the wire diagram for the 3 bar sensor you have and match the colors or just make sure the wire codes are the same that you match up from factory to the new one...or so i have read.
Last edited by brandon.beene; 06-18-2009 at 01:04 PM.
#12
Registered Member
Join Date: Apr 2003
Location: Richmond VA
Posts: 2,569
Likes: 0
Received 0 Likes
on
0 Posts
Re: 3 bar map sensor
Go on www.hondata.com . Its in their tech section. One wire is a +5V, one is GND, and the other is a signal wire. The pinouts are on hondata's site.
Thread
Thread Starter
Forum
Replies
Last Post