I just picked up a 92 civic, and the airbag assembly is not secured. Meaning if i take a turn the middle of the steering wheel slides out. I am not for sure how i go about getting this thing in there. it was never deployed, the wheel was removed for an aftermarket unit, then put back in. i am concerned for my safety and the fact it annoys the hell out of me. Any help would be appreciated...

 

I dont know if its on all hondas but there should be a yellow/red clip to put in where the air bag connects and if you put that in it wont go off

 

are you talking about the actual harness? i'm afraid the shit will fall out and go off!LOL

 

there is two wires connecting to the airbag, then a connector and theres another two wires going down the steering column. there should be a plastic piece in there that honda supplies to put in the connector so that it wont go off. you need power and ground for that to go off anyways

 

right, i want it to work though, i just want to secure it in place. I can't quite tell how it is bolted in..

 

check the sides of the steering wheel. there may be little rubber inserts in there that you can remove with screws.

 

i took those off already, they are on both sides, but when i look inside i can't see how i secure it.

 

I put one in my hatch along time ago and I though it' s a little phillips screw on each side

 

It actually take 4 torques screws. Hopefully it is just missing the screws and will be fixed for you tomorrow.

 

my man john. thats whats up man! i appreciate it. You do kick ass work man, thanks for always helping bro