92 DX to D16z6 conversion wiring help
#1
92 DX to D16z6 conversion wiring help
Okay I've searched on this forum and have yet to find out how and from where to where do I run the vtec wire from my d16z6 to my p28 ecu? Does anybody have a walkthrough with pics or diagrams this is my first swap I need help people. Thanks!
#2
S-T-F-U
Join Date: Nov 2004
Location: Isle of Wight "trash"
Posts: 531
Likes: 0
Received 0 Likes
on
0 Posts
Re: 92 DX to D16z6 conversion wiring help
Do you own a Haynes or any other manual? If not go buy one. In the back in the electrical diagram section, it will tell you which wire goes to the plug that conects to the ecu. If you want to run it and have it look stock, you have to pull pins from some other car and route them into the connectors that all your other wires go into. Their are 3 of them on the passanger side all stacked one on top of the other. Then rip apart the black pastic wire covers and route the wires and wrap it back up. Don't forget to smile, because your having fun.
#3
Re: 92 DX to D16z6 conversion wiring help
Oh, did I mention that I have the dx harness? What type of wire will I need to use if I don't want to waste my money on another harness?
#5
S-T-F-U
Join Date: Nov 2004
Location: Isle of Wight "trash"
Posts: 531
Likes: 0
Received 0 Likes
on
0 Posts
Re: 92 DX to D16z6 conversion wiring help
#6
Re: 92 DX to D16z6 conversion wiring help
I have the original DX harness partially attached to the car, engine and tranny are together. Just waiting to drop it in and wire it up.
#8
Re: 92 DX to D16z6 conversion wiring help
I don't have a vtec harness. I know theres a way to run a seperate wire from the solenoid to the ecu. I just don't know how to do it.
Thread
Thread Starter
Forum
Replies
Last Post