bellhousing help
#1
VTEC
Thread Starter
Join Date: Nov 2004
Location: Newport news 757
Posts: 1,543
Likes: 0
Received 0 Likes
on
0 Posts
bellhousing help
i have a b16 cable trans with cracked bellhousing and a ls cable trans with a good housing bad gears how hard would it be and how i would go about putting the ls bell housing on the b 16 trans any input would help
#3
superuser
Join Date: May 2003
Location: Glen Allen VA
Posts: 20,827
Likes: 0
Received 0 Likes
on
0 Posts
Re: bellhousing help
This link with pics may help. It's for an Integra, but close. You can also Google search for a "B16 Clutch install" which removing the bellhousing is one of the steps.
#6
Banned
Join Date: Jan 2005
Location: 757-Chesapeake
Posts: 1,919
Likes: 0
Received 0 Likes
on
0 Posts
Re: bellhousing help
It shouldn't be that hard.. the trans/bellhousing line up.
Just take out all the bolts, and there is a little bitch clip, but once you deal with that the bellhousing should come right off. Don't move anything around inside the trans because you got to line shit up somewhat if I remember correctly. Slide the new bellhousing on and you should be butter. If you want detailed instructions I can help you out.
..
also, Jarrod is selling EF B-series mounts.
https://www.vadriven.com/forums/showthread.php?t=171667
Just take out all the bolts, and there is a little bitch clip, but once you deal with that the bellhousing should come right off. Don't move anything around inside the trans because you got to line shit up somewhat if I remember correctly. Slide the new bellhousing on and you should be butter. If you want detailed instructions I can help you out.
..
also, Jarrod is selling EF B-series mounts.
https://www.vadriven.com/forums/showthread.php?t=171667
Thread
Thread Starter
Forum
Replies
Last Post