Solaeo

i was just wondering can a carbureted d15 be swapped out for a fuel injected d16 or d15 fuel injected, or could i just swap the head on the carbureted d15 from the fuel injected d15?

crazychickenhead

You'll need to swap out the fuel tank, pump, and lines... good luck

MA-HALF-E

Sell your carbs to Adrian.

MGBRaceman

I don't see why you would need to switch tanks, and upgraded fuel pump might not be a bad idea. I'm sure that you can convert to fuel injection without even pulling the head. You would need a manifold from an injected D15 if it fits, or an injection conversion for the carbureted D15. Either way you're going to need a manifold, injectors, a proper throttle body(ies), and an ecu to match.

BIGBALLS

just switch the intake manifold ecu and wire it up right and change the thottle cable its that easy

Solaeo

thks, i guess ill be doing that

Bert

check w/ hasport...according to them you would need to basically convert your car to a si...change tanks, lines, wiring harness...it would be cheaper and easier to get a si...

sargeek1975

You need a return line. Easiest way is to change gas tanks.