Let me know what you have. Planning a D-series build for my civic.

Mainly looking for full engine or block.

Thanks.

 

Fully built Y8 head. Shoot me a PM for all the details!

 

I see. Maybe intrested within a month.

Looking for complete bottom end right now or full engine.

 

I've got a d16z6 bottom end, head, and accessories just sitting in the garage along with SRP pistons, brand new rings, wrist pins, and spiro locks, along with PG6 rods.

 

Hey I have a dissassembled Y8 Block and Head with no valve cover. Its Been Hot Tanked and block shaved 5k's and crosshatched to clean it up. Crank needs to be turned or finished cleaning with emory cloth cause of spun bearing on rod 3 ........ Would like $250 for it all..... Block can be bored to whatever you want for $350 total and crank can be turned for an additional $100 let me know or just come get it for $250 oil pump was bad in it.. Came out of a 1996 honda civic ex

 

Also got a D16Y8 Stainless Header.

 

I need a working bottom end already assembled and ready to be mated with a head and tranny.

 

jake! its collin with the da! i may have the d16y7 out of mitches civic tomorrow lmk pm me

 

hey got a full cx swap motor, tranny, all the extra shit except harness

 

i have full z6 swap a si tranny stage four clutch master clutch a z6 motore needng valvle seels in car can drive right now will take 500 for everything tranny clutch axles motor harness it has a y 8 intake manifold motor has less than a 100 k on it will pull it after you drive it and decide if you want it eg stock mounts p28 lt me knowe pm me