Need help.Wiring harness?? conversion??
#1
got vtec?
Thread Starter
Join Date: Sep 2008
Location: VA BEACH
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
Need help.Wiring harness?? conversion??
so i was doing my swap today for the new d16 vtec in my crx, i was puttin the wiring harness together and i notice that the old wiring harness didnt have the plug for the d16 distriubter. the wiring harness was connected to a d15b2 before the swap, what do i need to do or buy so i can get the right plug for the distibuter???
#5
Re: Need help.Wiring harness?? conversion??
your welcome in advanced....u can either repin or cut and splice. find a obd1 eg harness, cut the 2 dizzy plugs off. if u plan to cut and splice leave about 4 inches. then cut your stock one. i spliced mine together and never had a problem. all the wire colors are the same, they all match up. there are 2 white wires, leave these for last. you have to pull back the loom and see which one sits outside the bunch, this will be considered the bigger white wire. ok heres a diagram i made. good luck.
OBD0 OBD1
orange) (orange
white) (white
orange/blue) (orange/blue
white/blue) (white/blue
blue/green) (blue/green
blue/yellow) (blue/yellow
large white) (yellow/green
black/yellow) (black/yellow
blue) (blue
OBD0 OBD1
orange) (orange
white) (white
orange/blue) (orange/blue
white/blue) (white/blue
blue/green) (blue/green
blue/yellow) (blue/yellow
large white) (yellow/green
black/yellow) (black/yellow
blue) (blue
Thread
Thread Starter
Forum
Replies
Last Post