I got an integra gsr with stage 3 exedy, i have to push the clutch all the way to the floor to switch gears. Theres way to much play in the pedal. How can I tighten this up so the car starts to move when letting out at the top.

Does this involve bleeding the master cylinder?

 

You could try bleeding the master cylinder, but make sure you bleed the clutch slave cylinder too.

 

id suggest the same

 

It is not likely bleeding will help unless you opened the system recently.

Crawl under the dash and look up where master is. You will see a rod going to the clutch pedal. There is a 12mm nut on it. brake it loose and adjust the pedal play by turning rod in or out of the clutch pedal.

 

x2

 

its wierd though, it tightens up as I drive