ls swap in crx help
#1
Registered member
Thread Starter
Join Date: Jan 2009
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
ls swap in crx help
I put I obd1 ls swap in my crx dx dpfi.it started right up but is throwing a cyp and map sensor code.I have tried 2 dizzy's and 3 map sensors and still getting codes.I have already went back and check wires for good connections.I'm used my factory dpfi harness and just converted it ova.I'm running open header to.has anyone had this problem
#2
Registered Member
Join Date: Jul 2009
Location: Culpeper
Posts: 749
Likes: 0
Received 0 Likes
on
0 Posts
Re: ls swap in crx help
does it rev up fine and idle fine? the throttle position sensor and map and the same plug you could maybe have those two plug switched around also the wiring harness is a pain in the a when usuing a dual point injection harness
#3
Registered member
Thread Starter
Join Date: Jan 2009
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
Re: ls swap in crx help
Yea I know the pluds are right cuz on a crx the map sensor is on firewall and I had to make I longer o reach
#5
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: ls swap in crx help
How did you check the wires for good connections?
Have you checked that you're getting 5VDC at the sensors?
There are three things that can go wrong here:
Any other problem is a byproduct of one of those things.
Have you checked that you're getting 5VDC at the sensors?
There are three things that can go wrong here:
- Bad sensor
- Bad wiring
- Bad ECU
Any other problem is a byproduct of one of those things.
Thread
Thread Starter
Forum
Replies
Last Post