Mustang SBF 302/351 Hi-Port/ Street Heat Cylinder Heads
#1
yea, i'm that guy
Thread Starter
Join Date: Feb 2003
Location: richmond, va
Posts: 2,049
Likes: 0
Received 0 Likes
on
0 Posts
Mustang SBF 302/351 Hi-Port/ Street Heat Cylinder Heads
I've got a set of original casting Street Heat cyl heads I need gone. *these are not the TFS Aluminum High Ports, these are the original early 90s cast iron heads. other than gasket-matching, these appear to have never been ported.
heads, valves, springs (good to .650 solid lift), keepers, studs, guide plates. Just need locks, valve stem seals, and to be put back together.
***** note: one port has damage, but has been repaired. previous owner got a little greedy trying to gasket match these heads and got into the push rod hole. it was drilled, sleeved, and epoxied??. repair appears to have been done at a machine shop and looks solid. I was saving these for a future project, but i need to move some things, and these gotta go.
the numbers on these heads are as follow:
head 1 - SAR 1274 S/N 990__ 0305
head 2- SAR 1274 S/N 990-2 0330
no where is there a casting of a brand that i can tell on either of these heads, i can only assume they are original kpi stuff. if someone wants to correct me, please do
2.02/1.60 valves. no idea what cc the chambers are, sorry.
pics:
Asking $700
804-874-2874
please be sure to leave a message
heads, valves, springs (good to .650 solid lift), keepers, studs, guide plates. Just need locks, valve stem seals, and to be put back together.
***** note: one port has damage, but has been repaired. previous owner got a little greedy trying to gasket match these heads and got into the push rod hole. it was drilled, sleeved, and epoxied??. repair appears to have been done at a machine shop and looks solid. I was saving these for a future project, but i need to move some things, and these gotta go.
the numbers on these heads are as follow:
head 1 - SAR 1274 S/N 990__ 0305
head 2- SAR 1274 S/N 990-2 0330
no where is there a casting of a brand that i can tell on either of these heads, i can only assume they are original kpi stuff. if someone wants to correct me, please do
2.02/1.60 valves. no idea what cc the chambers are, sorry.
pics:
Asking $700
804-874-2874
please be sure to leave a message
Thread
Thread Starter
Forum
Replies
Last Post