Delete

Wondering if anybody has ever put type r rods in a single cam or heard of anybody doing this. Idk if it will take much work to have it done so any suggestions will help. Thanks

 

? why would you wanna do this and people have put ls rods in them before but never heard using type R rods

 

BC I have the rods Just laying in garage so I figured I'd put them to use instead of buying aftermarket rods.

 

I think they have to be milled to match the narrower single cam crank and also need to have a sleeve pressed in to reduce the size of the wrist pin bore. I think the block has to be clearanced too. I can't remember how the crank length matches up. I've never done it, because I can't see spending any money to modify a set of stock rods when you can buy a set of aftermarket D-series rods for pretty cheap. Actually, the real reason is that I don't do anything with single cam engines.

Anyway, I'd sell the ITR rods and buy a set of proper rods for your engine. There isn't going to be too much price difference since you would have to pay to get the ITR rods modified.

 

I picked up a set of Scat rods off ebay BNIB for 309 shipped...

 

Alright thanks fellas

 

or just buy a ls motor for a hundred bucks