To my friends in Roanoke, here is my new setup and dyno!
#21
Re: To my friends in Roanoke, here is my new setup and dyno!
Originally Posted by IntegraXSi
Thats a good deal.... 2500 for that set up I would take it
#22
Thread Starter
Nonvtec owns you
Joined: Dec 2004
Posts: 222
Likes: 0
From: Roanoke, VA/ San Diego, CA
Re: To my friends in Roanoke, here is my new setup and dyno!
Originally Posted by IntegraXSi
Thats a good deal.... 2500 for that set up I would take it
Nonvtec parts are dirt cheap!
#23
Thread Starter
Nonvtec owns you
Joined: Dec 2004
Posts: 222
Likes: 0
From: Roanoke, VA/ San Diego, CA
Re: To my friends in Roanoke, here is my new setup and dyno!
I've got a new project now. With my other LS block(may get a B20 block w/ a P8R head), Im going to stroke it(95mm), run bigger cams(crower 405's), higher compression(12.5:1), and up the TB to a 70mm. Then it'll be back to the dyno to see what I can push it out to. An Allmotor LS/B20 with 220+ whp would be nice!
The calls are going in to Brian Crower at Crower and Larry at Endyne to see what they can do for me. More will be up on this project later on.
Comments, Suggestions........
The calls are going in to Brian Crower at Crower and Larry at Endyne to see what they can do for me. More will be up on this project later on.
Comments, Suggestions........
#25
Thread Starter
Nonvtec owns you
Joined: Dec 2004
Posts: 222
Likes: 0
From: Roanoke, VA/ San Diego, CA
Re: To my friends in Roanoke, here is my new setup and dyno!
Originally Posted by GaRn
sounds badass, but id be suprised if you could pass the 200 whp mark.. it will be rather close..
I dont doubt it. There is a guy in Maryland with 200whp out of a B20 with similiar mods to what I have for the exception of ITB's
Thread
Thread Starter
Forum
Replies
Last Post