MPFI swap???? Help
#1
MPFI swap???? Help
How would you go about doing this swap without using a resistor box? *(is this even possible)
Got the idea from this: http://honda-tech.com/zerothread?id=1275711
if this is possible what parts do I need??
Got the idea from this: http://honda-tech.com/zerothread?id=1275711
if this is possible what parts do I need??
#3
Re: MPFI swap???? Help
i have the whole obd-1 setup (injectors, distributor, etc) how would i go about doing a mpfi swap with these parts.
Its a crx dx with a d15b7 motor. All the dual point stuff swapped over on the b7 and wanting to do a mpfi swap using the mpfi stuff if possible.
Its a crx dx with a d15b7 motor. All the dual point stuff swapped over on the b7 and wanting to do a mpfi swap using the mpfi stuff if possible.
Last edited by skybluecrx; 06-13-2005 at 12:22 PM.
#4
Re: MPFI swap???? Help
You will need to use obd-1 or 2 injectors. Then you take the 4 yellow wires that would go to the resistor box and wire them together. Then splice the wires wires into the red wires that go to the resistor box. Did it on my b16 setup so I know it works. The red wires are 12v's but obd0 injectors are like 6-8v's so thats why you need the resistor box. However obd1/2 injectors are 12v. I also have a risistor box for sale if you want one. $10
Thread
Thread Starter
Forum
Replies
Last Post