dat iz da sekks!

 

wait till i post my pics tomorrow

 

Hell yeah! Your piping looks better than mine

 

arnel, i got a friend that needs some i/c piping done, you busy?

 

Yes sir I am. I'm attached to a ship all week, plus I have no piping..... Thanks for the bump Leo

 

when can you come check it out?

 

ha ha..... What I meant was, "I am busy Leo". I can, however, take a look at it and give some advice on routing the pipe. RJ at Direct Performance should be able to hook him up with a fabricator/welder if he needs it soon. I'm just really swamped.

On a side note, here's the latest fab I did on Mark's car:
http://www.dragva.com/forums/showthread.php?t=145080

 

UPDATE:
I just received a shipment of 3 inch mandrel bent piping. I still have some 2.5 inch piping as well.

For the time being, I do NOT want to do exhaust systems. I will finish mark w and Grease Monkey. I'm still sorting out sources for longer straight pipe. Once I have established a source, then I MIGHT start doing them again. Currently, all I have is a long section of 3 inch STAINLESS piping. If you want that installed in your car, let me know. The price will be higher than my normal charges due to cost of material.

Please do not get me wrong. I WILL continue to do downpipe systems.

 

These services are currently on HOLD until I get settled into my new house. I will update and edit this thread until then. Thanks for looking.....

 

I was wondering if you are able to make a downpipe from a 18G turbo for a integra GSR. Im currently trying to piece together the turbo kit but if you can make a downpipe for me then I will just buy one off of you istead of buying the elbow and downpipe. Im in springfield va so i can't bring the car to you. This is for a integra with a Greddy manifold and Greddy 18G turbo.