B20 Build information.
Thread Starter
braap braap
Joined: Jul 2003
Posts: 14,536
Likes: 0
From: Portsmouth
B20 Build information.
Hello.
I have a B20 block with a block guard pressed in. I was wondering what tool I could use to take it out. The block isn't sleeved, and I got the motor from a friend. Motor was never ran with the block guard installed, it's just "pressed" in.
He basically took a piece of wood and hit it in.
Also.
Motor(bottom end wise) is a stock b20b crank. I have a AZracemachine.com crank girdle. The motor will be abused, and I got it for free. Is it worth to install?
I'm new to the non-vtec build stuff. And I'm looking for advice.
The motor will most likely be boosted on. If I don't boost it, I have a header, head/cam/intake-manifold setup for it.
Right now, it's just a stock rebuild. (ran fine, but friend tore it down to build it. He ran outta money so I scooped it up)
I have a B20 block with a block guard pressed in. I was wondering what tool I could use to take it out. The block isn't sleeved, and I got the motor from a friend. Motor was never ran with the block guard installed, it's just "pressed" in.
He basically took a piece of wood and hit it in.
Also.
Motor(bottom end wise) is a stock b20b crank. I have a AZracemachine.com crank girdle. The motor will be abused, and I got it for free. Is it worth to install?
I'm new to the non-vtec build stuff. And I'm looking for advice.
The motor will most likely be boosted on. If I don't boost it, I have a header, head/cam/intake-manifold setup for it.
Right now, it's just a stock rebuild. (ran fine, but friend tore it down to build it. He ran outta money so I scooped it up)
Thread
Thread Starter
Forum
Replies
Last Post