Ok this is for the 240 guys. I am doing the z32 brake upgrade on my base model 240. It is 4 lug. I have all the parts for a 5 lug conversion...well most of them...the rest of them should be here today. But I am just curious if I will need a slide hammer to remove the hubs from my car? and also what size are he hub nuts....I think s14 are 36mm front and 32mm rear...can some one help me? Greaser...=) or anyone else with this knowledge. thanks all.

 

The FSM makes no mention of using a slide hammer. You will probably need to use a hammer or puller to remove the driveshaft.

What are you talking about hub nuts? You mean wheel studs, maybe lug nuts, or the wheel bearing lock nut? I'm not sure what you're asking about.

 

I think he means that.

 

yeah that's what I mean. =) I never really see any 36mm/32mm lug nuts. =)

 

If you don't find out the sizes I can measure mine when I get home ... if I remember.

 

thanks. but that might be too much trouble. You have to take your rims off, I'll look on FA or zilvia.

 

found it
S14 front 32mm and rear is 36mm

 

If you need torque specs I have them......

 

I'm gonna use german specs....gude un tight. =) I dont' have a torqe wrench. that might be on my list of crap to buy...but I'm broke...3,000 in suspension and brakes and still not even close to being done.

I should have bought an SUV!

 

N-m (kg-m, ft-lb)

Front: 206-284 (21-29, 152-210)
Rear: 206-275 (21-28, 152-203)