ok i am trying to do a mpfi i have most of the wiring done but i need a good write up on how to do the obd1 injector swap as in what wires do i splice together and where does the wires go in the wire loom does that make any sence i dont know but it is driving me nutty i dont want to have to use a resister box i know you can do the swap with out it i also doing an obd1 swap(thats obvious) could someone please help

 

http://www.geocities.com/teampimports/fuelinj.html

that should give u a start

 

i think i have a better write up on my laptop ill get back to u in a sec

 

http://www.50mod.com/fourthgenhatch/mpfi.html

there ya go

 

thanks dabrat i have seen both of those but they dont talk about the when wiring the obd1 injectors

 

it should be the same

 

You should punctuate your sentences, that whole glob was a pain to read. Did you just try google'ing it?

 

For obd1 you take all the wires that run to the resistor box and wire them together. Should be the 4 wires from the injectors and the the 2 wires from the old dual point injectors that they tell you to wire together and run to the resistor box. It will be the 2 yellow and black wires from the old injectors that run to the resistor box and the 4 red and black wires from the new injectors.

 

hmmmmmmmmmmmmmmmmmmm My be im just dumb but i still dont get it god im so stupid i guess. there are these wire #1 injector(brown, Yellow-black)#2 injector i have (red, yellow-black) # 3 injector(Lt blue, yellow-black) #4 injector(yellow, Yellow-black). I have no clue what the heck to do. Maybe someone needs to break it on down barney style or something. Anyone else wanna help??????

 

no body has any input at all?????????