I have a 96 accord lx with a multiple misfire code in all cylinders and manufacturer control malfunction. what would be the cause and how would I be able to correct it? thanks

 

get rid of it haha

 

Was it a shop or Autozone that pulled the codes? Most likely a tune up related issue, but it could go deeper.How many miles on the car and what is it's maintenance history?

 

FYI, i was told autozone could no longer pull codes for people (in this area, 757) because they would direct people what to buy and they would often be wrong.

 

Distributor or coil packs? Bad or faulty ecu? those are my guesses other than like stated,a regular tune up.

 

i pulled the codes i have a scaner. history is good ive had the motor for about 4 years i put it in this shell about 1 1/2 ago it has new plugs, cap, rotor ,fuel filter .. all has been done the motor has 150k on it .. the car over 240k. is there a way to check the ecu?

 

New Wires? Any moisture in spark plug tubes? Did this happen after putting on new cap/rotor?

If those all check out, sounds like your igniter/module in the distributor may be going poop.

 

it did it before and after .. the car seems to do it when its at 4500 rpm stedy when drivin it. dosent do it when reving.. only on a load

 

Under load is more of an indicator that it is in the tune. Check for bad plugs, wires, cap rotor. Visually inspect them. Also check for oil down in the spark plug valleys.

 

is it runnig rough? it could be bad gas or have you put in any fuel additive latley ive seen that throw misfire codes also a simple tune up could possibly fix it