Throttle body???
#1
98 civic -rebuilding
Thread Starter
Join Date: Jul 2006
Location: 27577
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
![zach byrd has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
Ok I will start by saying I have a D16y8 with a Skunk2 intake manifold. I want to get a throttle body for the intake manifold but do not know what would be best for this setup. I was also wondering what the stock bore for my y8 throttle body is and what bore I should go with? I have heard that the type r would bolt up perfectly and would be a good option. Any feedback would be helpful. thanks!
#2
Registered Member
Join Date: Jul 2007
Location: roanoke
Posts: 449
Likes: 0
Received 0 Likes
on
0 Posts
![93turboeg has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
Ok I will start by saying I have a D16y8 with a Skunk2 intake manifold. I want to get a throttle body for the intake manifold but do not know what would be best for this setup. I was also wondering what the stock bore for my y8 throttle body is and what bore I should go with? I have heard that the type r would bolt up perfectly and would be a good option. Any feedback would be helpful. thanks!
#3
![Default](images/icons/icon1.gif)
not sure of your budget, but if I were you and could put down a little cash, pick up anything cheap that can be bored that big, then send it to maxbore.com with your new manifold and get it portmatched and cleaned up. Check on the site to see what tb's you can use.
Thread
Thread Starter
Forum
Replies
Last Post
eXploited
Parts ARCHIVE
3
01-07-2008 06:11 AM