EF B Series swap/ axles?
#1
Registered Member
Thread Starter
Join Date: Aug 2004
Location: Newport News
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
EF B Series swap/ axles?
Originally Posted by PasswordJdm.com
Here is an original JDM 4x100 Front Disk Brake Conversion for an EF Civic/CRX only. Originally came from a B16A EF8/EF9 SiR! This is a MUST if you are swapping a B-series into your EF non-SI because the B-series axles will not fit into non-SI hubs. Plus you get the added B16 front brakes to handle your larger motor swap as well!!
I have an 89 Hatch, non-si.
Do I have to get new knuckles to fit b-series axles?
Teggy knuckles will work, if so?
Will the b-series axles length match?
Last edited by invertedintegra; 05-15-2008 at 03:58 PM. Reason: axle length
#2
Re: EF B Series swap/ axles?
Only hf's i believe need new hubs. And use 90-93 teg axles (non abs) for the swap. Teg knuckles will work also, but your's should work anyways.
#3
Re: EF B Series swap/ axles?
STD models ( standard 4 speed tranny models ) need to change the front hubs out for DX or SI model hubs. If you have a five speed transmision stock ( DX ,SI ) then you can use your stock hubs.
#7
Registered Member
Join Date: Mar 2006
Location: alexandria
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Re: EF B Series swap/ axles?
as long as your 89 hatch is a dx or si your good to go... the standard hatch is the equilivent to the hf crx.. you can use the da axles either abs or not just remove the dust covers on the the hubs...
Thread
Thread Starter
Forum
Replies
Last Post
JDMB16CRX
Want to Buy / Trade ARCHIVE
8
08-07-2008 08:13 AM
gotboosthatch
Parts ARCHIVE
10
07-30-2007 11:05 PM