vafc problem
#1
Registered Member
Thread Starter
Join Date: Mar 2006
Location: Norfolk
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
vafc problem
ok so i let my dad borrow my car over the weekend while i was gone, and when i came back he told me that he was pushing buttons on the VAFC trying to get it back to the regular display screen because he hit it on accident and went into the menu(he had no idea what he was doing) and now its running crappy...the check engine light comes on very often under mild to hard accelaration can someone that knows what they are doing look at it or help me...
#4
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: vafc problem
Get it chipped and tuned, and ditch the VAFC.. You have the perfect setup for ECU tuning, and it's much less compromised than a piggyback like the VAFC. Then you'll never have to worry about stuff like this again, and your engine will run the way it's supposed to.
#5
Word..aight then!
Join Date: May 2008
Location: Winchester, Va.
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Re: vafc problem
Don't worry man, whatever he did is an easy fix. What screen is it on right now? He may have just leaned it out at a certain RPM or something. The car still drives so he didn't change anything major. No terrible engine noise, right?
#6
Registered Member
Thread Starter
Join Date: Mar 2006
Location: Norfolk
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Re: vafc problem
well when i got there it was on the sensor# screen, but that as after pressing god knows how many different buttons...is there any way to just reset it to stock settings or to unplug it and not use it for now, or where can i get it tuned?
#7
TurboPipingSystems
Join Date: Jul 2003
Location: USDM Land, Va Bch
Posts: 1,483
Likes: 0
Received 0 Likes
on
0 Posts
Re: vafc problem
no, unplugging the harness will not place it back to stock configuration. If the unit was installed properly, there are 2 sensors (wires) that should've been cut and reconnected: MAP and VTEC.... meaning if you disconnect the AFC harness, then those 2 sensors will also be disconnected. The best thing to do is go to the ETC menu and select "initiate". That should bring it back to stock setting. If u get confused, PM me.
Thread
Thread Starter
Forum
Replies
Last Post
TheMx3
Tech Talk
11
02-03-2004 01:18 PM