b18a machining questions
#11
Registered Member
Join Date: Apr 2003
Location: Richmond VA
Posts: 2,569
Likes: 0
Received 0 Likes
on
0 Posts
Re: b18a machining questions
whats the setup on the car? Stock bore is 81mm. Personally i wouldn't go to 84mm without going with aftermarket sleeves. Most people with stock sleeves will usually go out to 81.5mm.
#12
I have a 20 valve...
Join Date: Nov 2002
Location: Sunny San Diego, CA
Posts: 3,266
Likes: 0
Received 0 Likes
on
0 Posts
Re: b18a machining questions
I had 83mm on my b18 setup and didn't have to sleeve it. it ran great and the block had 220k miles on it when I did the machining.
Thread
Thread Starter
Forum
Replies
Last Post