New b18 swap wont start
#1
Registered member
Thread Starter
Join Date: Oct 2008
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
New b18 swap wont start
I'm new to the game of imports. I'm not new to building motors. I have a b18 swap in a EG and I just got it all together and it wont start. I had my computer with a base map, I have a 3 bar map sensor installed and I have 1000cc injectors. The clips had ceramic type resistors that came with them. I think that I'm getting spark (did the old screw driver to metal test). I'm getting fuel to the rail but not sure if the injectors a working. How can I determine this and do I need the resistors? The color of the wires on the clips are not the same as the wires in the harness. How do I know if I have positive to positve and neg to neg?
#3
VAdriven Sponsor
Join Date: May 2005
Location: Virginia Beach
Posts: 4,390
Likes: 0
Received 0 Likes
on
0 Posts
Re: New b18 swap wont start
for the injectors take a multimeter and check the ohms of each injector low reading 2-6 u need a resistor box, high reading 10-15 u dont need one, and it doesnt matter which wire is pos. or neg.
Thread
Thread Starter
Forum
Replies
Last Post