need help,what does a spun bearing sound like?
#1
Registered Member
Thread Starter
Join Date: Feb 2009
Location: p-town
Posts: 531
Likes: 0
Received 0 Likes
on
0 Posts
need help,what does a spun bearing sound like?
my car started running like sh*t and i can hear a lot a vibration that sounds like its coming from the bottom end(vibrating the dash n what not like crazy)any one describe what a bad bearing sounds like????
#2
Double Agent HT
Join Date: Nov 2004
Location: Installing Your Theater
Posts: 5,518
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help,what does a spun bearing sound like?
when I spun a bearing, the motor stopped running.
I say check the oil, get on the highway and do 100+ in third gear for 10 min straight, should clear out whatever build up you have.....
just kidding
I say check the oil, get on the highway and do 100+ in third gear for 10 min straight, should clear out whatever build up you have.....
just kidding
#3
Re: need help,what does a spun bearing sound like?
It's also called rod knock because, it sounds like a knocking noise. Does the knocking get faster as you rev the engine (at a stand still/neutral)? Is the volume louder or quieter while driving under load (driving on the road vice neutral)? If you believe you have a crushed bearing, you'll have debris in your oil, so drain your oil into a container that you'll have open access to. Wade around this with a mechanics magnet (magnet on a telescoping antenna looking type deal) or some other worthwhile magnet (those bendable type that stick on the fridge doesn't qualify as worthwhile imo). Did you pick up shreds/bits of metal?
Check your engine mounts too, though the running like shit part. Hmm. Having a shot spark plug/wire and bad engine mounts would act like you describe, since you didn't mentioning a knocking/banging type of noise.
What noise is there?
Check your engine mounts too, though the running like shit part. Hmm. Having a shot spark plug/wire and bad engine mounts would act like you describe, since you didn't mentioning a knocking/banging type of noise.
What noise is there?
#5
Registered Member
Join Date: Aug 2004
Location: woodbridge
Posts: 4,374
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help,what does a spun bearing sound like?
LOL, well i would say do that if you plan on replacing the motor, might make for a good story later!!!
#6
Registered Member
Thread Starter
Join Date: Feb 2009
Location: p-town
Posts: 531
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help,what does a spun bearing sound like?
well,its been burning alot of oil,so i knew it was going to need to rebuild it,and it was knocking too.but last night driving home it started to sound like my lug nuts were loose on one of my front tires,so i checked when i got home and they were good.about an hour later when i went to start it it was making strange sounds that i've never heard from an engine before.it was like a deep vibration, pulsating at idel.and when i drove it it sounded worse.it was vibrating the dash so much that it sounded like it would fall off if i let it run long enough.i'm going to change the oil and sift through it to see if i pick up any metal shavings tonight.
#7
Registered Member
Join Date: May 2009
Location: Fairfax
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help,what does a spun bearing sound like?
a spun bearing sounds like a ticking that matches the rpm; if you rev it up and the ticking revs up equally with the rpm, then it might be a spun bearing. its not too tough to check though...pull the oil pan off and you can get at the rod caps and see for sure.
#8
Fidel runs VBPD
Join Date: Oct 2004
Location: Norfolk, VA
Posts: 2,101
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help,what does a spun bearing sound like?
well,its been burning alot of oil,so i knew it was going to need to rebuild it,and it was knocking too.but last night driving home it started to sound like my lug nuts were loose on one of my front tires,so i checked when i got home and they were good.about an hour later when i went to start it it was making strange sounds that i've never heard from an engine before.it was like a deep vibration, pulsating at idel.and when i drove it it sounded worse.it was vibrating the dash so much that it sounded like it would fall off if i let it run long enough.i'm going to change the oil and sift through it to see if i pick up any metal shavings tonight.
#9
Re: need help,what does a spun bearing sound like?
Signs of a spun bearing
Significant loss of oil pressure,
Loss of power
Inability to idle without throttle
If you had rod knock before, a spun bearing or a rod out the side of the block usually follow soon after.
Significant loss of oil pressure,
Loss of power
Inability to idle without throttle
If you had rod knock before, a spun bearing or a rod out the side of the block usually follow soon after.
#10
Digital Life
Join Date: Feb 2006
Location: Worldwide
Posts: 4,850
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help,what does a spun bearing sound like?
Of course I sounded like a diesel truck.
Thread
Thread Starter
Forum
Replies
Last Post