Suspension Help 99 SI
#1
Registered Member
Thread Starter
Join Date: Jan 2006
Location: Fredericksburg
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Suspension Help 99 SI
I have a 99 SI, when i first bought the car i realized that the passenger rear tire wasn't even with the driver side rear. Basically, the passenger side tire had a half inch gap from the fender well and the driver side rear had about a 1 and a half to a 2 inch gap. Im a tool when it comes to suspension so bare with me. I think its the bolt on the control arm? It was missing and it was wedged between 2 pieces of metal underneath car. So i jacked the car up and took a pry bar and pried out the control arm and found the hole it was supposed to go into. After i did that i couldnt get the bolt started. I jacked the car back down and the tire was even as could be, it was dead center in the middle. Believe it or not tire wear on the back tires are even, even with that bolt just sittin in there. Any ideas what i could do? I can't really see in there where the hell the whole lines up. Anybody have this problem or am i just shit out of luck...
#2
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: Suspension Help 99 SI
So you've looked at the other side of the car and observed how everything fits together..? It shouldn't be that hard to find where the bolt goes, and if you can look at the other side of the car you can see if you're also missing a nut on the other side.
It would be very helpful to take a picture so people know what you're talking about..
It would be very helpful to take a picture so people know what you're talking about..
Thread
Thread Starter
Forum
Replies
Last Post
lionman197924
Parts ARCHIVE
2
10-04-2007 06:47 PM