Weds would be dope. Especially if you could get these:



They apparently only come in 15X8.5 -10, haha.

16X7 +38 SA-70s don't look bad at all though:



Some 15mm spacers and a 205/45 and you'd be set!

 

lol, that ish would be dank hahaha.. i gota sell my boat now!

iv been considering spacers but.. idk are they any safe? id imagine there would be some kind of safety hazard.. or would i have to get extended studs?

 

Get bolt on spacers, 240 guys run 50mm spacers on drift cars, so you'll be fine with a 15mm bolt on spacer for the street. I ran 15 and 20mm spacers on my old wheels for over a year with no issues at all. Just make sure they're hub centric and you torque them down right.

 

tru tru, any particular name brand?

 

Could roll on some GT3s or some DR16s

Even if it is a DD, still moar lower!

I know when I get my teg I am going to try to get it as low was possible. But yeah, there are a lot of good suggestions.


No problem, I saw a picture of a silver EK coupe with some polish slips and it looked straight sexy. I mean even as close as your girls white coupe with the polished rims she has. Looks nasty.

 

Project Kics are the best by far. I believe Sage Auto just became a distributor of them. The best part about those spacers is they are not terribly more expensive then the ebay ones and they are literally the nicest spacers I've ever seen before.

 

nice, ill check them out! thanks!