B20 BLOCK
#1
Registered Member
Thread Starter
Join Date: Jan 2008
Location: Near Charlottesville
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![Default](images/icons/icon1.gif)
Ok my cousin got a b20 that is hard to rotate, the block has been bored out to 85mm, its got a knife edged eagle crank, eagle rods, wiseco pistons and some king bearings. the block was put together and we tried to put at tdc and it was extremely hard to turn, he had to put a jack handle on the ratchet so he could get it spining.
do you guys know what could be wrong?
#3
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
![Fabrik8](images/reputation/reputation_pos.gif)
![Fabrik8](images/reputation/reputation_pos.gif)
![Fabrik8](images/reputation/reputation_pos.gif)
![Fabrik8](images/reputation/reputation_pos.gif)
![Fabrik8](images/reputation/reputation_pos.gif)
![Fabrik8](images/reputation/reputation_highpos.gif)
![Fabrik8](images/reputation/reputation_highpos.gif)
![Fabrik8](images/reputation/reputation_highpos.gif)
![Fabrik8](images/reputation/reputation_highpos.gif)
![Fabrik8](images/reputation/reputation_highpos.gif)
![Fabrik8](images/reputation/reputation_highpos.gif)
![Default](images/icons/icon1.gif)
Yeah, yank the crank bearing caps and test the clearances with plasti-gauge. Not having spark plugs installed will usually help too because it can't build cylinder pressure while being turned.
#4
Registered Member
Thread Starter
Join Date: Jan 2008
Location: Near Charlottesville
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![Default](images/icons/icon1.gif)
the head is not bolted on, we even pulled it apart and tried the stock crank just to see if it was the crank, but we still had the same issue. i guess we're going to plasti-gauge it, its the only thing left to do.
#8
Registered Member
Thread Starter
Join Date: Jan 2008
Location: Near Charlottesville
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![slo_b18](images/reputation/reputation_neg.gif)
![Default](images/icons/icon1.gif)
no it was not platiguaged, and yes everything was torqued to the right specs and in the right sequence. (i guess we're going to platiguage)
#9
Thread
Thread Starter
Forum
Replies
Last Post
ridinboost757
Want to Buy / Trade ARCHIVE
2
10-02-2008 05:35 PM