Vtec Wiring
#1
Registered Member
Thread Starter
Join Date: Dec 2009
Location: Springfield,VA
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Vtec Wiring
I am new to Hondas and I am acctually looking for one, well I came accross this nice civic with a vtec swap, but the vtec is not wired up....How hard will it be to wire it up or how much would it cost for it to get wired up????? dont bash please, again im new to hondas
#3
Registered Member
Thread Starter
Join Date: Dec 2009
Location: Springfield,VA
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
#5
Re: Vtec Wiring
look at this picture
see the green plug, look to see if you have what the green plug plugs into. its the vtec solenoid as seen in the following picture
http://www.octagonwebdesign.com/b16/...CF0107_JPG.jpg
as long as you have this solenoid your in luck and the guy isnt trying to cheat you.
this is how its supposed to be wired (its really easy)
http://ef-honda.com/ben/OPSnVTECsol.jpg
STOP!! THIS IS FOR A OBD1 P72 ECU!!!! - i need to know if your car is obd0 or obd1 then i can tell you the right pinouts. however im going to list what i think you have, which is a obd1 p72 ecu.
-the solenoid has one wire coming from it which goes to A4 on your ecu
-the pressure switch has 2 wires coming from it which goes D6 on your ecu the other wire goes to any ground.
the following image shows excatly where on the ecu these are.
http://www.ff-squad.com/tech/wiring/wiring.92-95.jpg
hope that helps.
see the green plug, look to see if you have what the green plug plugs into. its the vtec solenoid as seen in the following picture
http://www.octagonwebdesign.com/b16/...CF0107_JPG.jpg
as long as you have this solenoid your in luck and the guy isnt trying to cheat you.
this is how its supposed to be wired (its really easy)
http://ef-honda.com/ben/OPSnVTECsol.jpg
STOP!! THIS IS FOR A OBD1 P72 ECU!!!! - i need to know if your car is obd0 or obd1 then i can tell you the right pinouts. however im going to list what i think you have, which is a obd1 p72 ecu.
-the solenoid has one wire coming from it which goes to A4 on your ecu
-the pressure switch has 2 wires coming from it which goes D6 on your ecu the other wire goes to any ground.
the following image shows excatly where on the ecu these are.
http://www.ff-squad.com/tech/wiring/wiring.92-95.jpg
hope that helps.
Last edited by enot767; 12-28-2009 at 08:45 PM.
#6
Registered Member
Thread Starter
Join Date: Dec 2009
Location: Springfield,VA
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post