swapped ef trouble
#1
Registered Member
Thread Starter
Join Date: Jul 2008
Posts: 652
Likes: 0
Received 0 Likes
on
0 Posts
swapped ef trouble
ok so i traded for a EF hatch with a b18c1 block,b16 head, drove car an hour and 40 min home with no problems, start it up 2 days later and it will not rev over 3000 rpms,i wait like 6-7 hours start it up again and it runs fine for first 10-15 min the will not rev over 3000 rpms again....any sugestions as to what this might be???
#2
Registered Member
Join Date: Jul 2005
Location: Richmond
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
Re: swapped ef trouble
#6
Re: swapped ef trouble
is it using an obd0 / I / II ECU?
OBD0 codes are read right at the ECU.
key switch on produces 1 blink to show ECU is getting power. then codes are flashed if there are any.
OBD0 codes are read right at the ECU.
key switch on produces 1 blink to show ECU is getting power. then codes are flashed if there are any.
Thread
Thread Starter
Forum
Replies
Last Post
itslogz
Want to Buy / Trade ARCHIVE
10
04-09-2008 11:01 AM
Worlds Greatest
Want to Buy / Trade ARCHIVE
2
02-24-2008 08:31 AM
turon082383
Want to Buy / Trade ARCHIVE
0
09-04-2007 02:57 PM