shitty ls
#1
shitty ls
I put a obd1 ls in my 88 obdo hatch. Already did muliti point for my zc that i had in previously. SWap the dizzy plugs to work with my obdo harness. Car starts and runs well but when i drive first and second are fine however when i shift to third the the motor revs high then when i shift to fourth and fifth it runs normal again. Cant figure this out. Oh and before i forget i have a obd1 to obdo conversion harness with a socketed i assume pr4 but the id tag on side of ecu has been removed and someone wrote with a sharpie ( SOCKETED NON-VTEC 5 SPEED) on the side. Any ideas would be greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post