replaced valves now i have a power loss at about 4-5000rpm
#1
replaced valves now i have a power loss at about 4-5000rpm
i had 3 bent valves and replaced them this weekend and now when i go into vtech it stops pulling about 4-5000 rpms and replaced then stock manifold with a skunk2 one. does anyone know what this could be from? shit is very annoying
#3
Registered Member
Join Date: Sep 2010
Location: Ceemorecock GA
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Re: replaced valves now i have a power loss at about 4-5000rpm
If your flowing much more air than stock, you could be leaning out. Get your hands on a wide band A/F ratio sensor to be sure. Lean mixtures burn shit up....
#5
BROSCIENCE
Join Date: Apr 2009
Location: Lynchburg area
Posts: 4,429
Likes: 0
Received 0 Likes
on
0 Posts
Re: replaced valves now i have a power loss at about 4-5000rpm
It's probably because you mistakenly put a phone in your motor instead?
#6
Registered Member
Join Date: Sep 2010
Location: Ceemorecock GA
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
#7
BROSCIENCE
Join Date: Apr 2009
Location: Lynchburg area
Posts: 4,429
Likes: 0
Received 0 Likes
on
0 Posts
#8
Registered Member
Join Date: Sep 2010
Location: Ceemorecock GA
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Re: replaced valves now i have a power loss at about 4-5000rpm
If I had known that, I woulda spelled it for you. But!, you did spell "it" correctly. Your not fucking helping bent valves whatsoever! I can't even spell whatever so fuck off!! I will rebuild your motor tho.... fuck! I meant though.... so fuck off...
#9
DUKE BLUE DEVILS
Join Date: Nov 2002
Location: Yorktown
Posts: 6,075
Likes: 0
Received 0 Likes
on
0 Posts
#10
BROSCIENCE
Join Date: Apr 2009
Location: Lynchburg area
Posts: 4,429
Likes: 0
Received 0 Likes
on
0 Posts
Re: replaced valves now i have a power loss at about 4-5000rpm
From my understanding he doesn't have bent valves anymore. Also my spelling is correct.
Thread
Thread Starter
Forum
Replies
Last Post